Publicidad
All manuals and user guides at all-guides.com
5 - 39
FRONT FORK
4. Tighten:
Pinch bolt (handle crown) 1
G
23 Nm (2.3 m · kg, 17 ft · lb)
Pinch bolt (under bracket) 2
G
20 Nm (2.0 m · kg, 14 ft · lb)
CAUTION:
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
Brake hose holder 1
G
Caliper 2
G
Bolt (caliper) 3
G
23 Nm (2.3 m · kg, 17 ft · lb)
NOTE:
Fit the brake hose holder cut a over the pro-
jection b on the front fork and clamp the brake
hose.
6. Install:
Brake hose holder 1
G
Bolt (brake hose holder) 2
G
10 Nm (1.0 m · kg, 7.2 ft · lb)
Protector 3
G
Bolt (protector) 4
G
10 Nm (1.0 m · kg, 7.2 ft · lb)
NOTE:
When installing the brake hose holder, align
the top a of the brake hose neck with the
brake hose holder bottom b. Then pass the
brake hose 5 in front of the axle boss c and
fit it into the hose groove d so that the brake
hose does not contact the nut (wheel axle).
7. Adjust:
Rebound damping force
G
NOTE:
Turn in the damping adjuster 1 finger-tight
and then turn out to the originally set position.
CHAS
Publicidad
Capítulos
