Publicidad
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
All manuals and user guides at all-guides.com
3 - 29
Loosen the pad pin 2.
G
Remove the brake hose holder 3 and cal-
G
iper 4 from the front fork.
Remove the pad pin and brake pads 5.
G
Connect the transparent hose 6 to the
G
bleed screw 7 and place the suitable con-
tainer under its end.
Loosen the bleed screw and push the cali-
G
per piston in.
CAUTION:
Do not reuse the drained brake fluid.
Tighten the bleed screw.
G
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
Install the brake pads 8 and pad pin.
G
NOTE:
Install the brake pads with their projections
G
a into the caliper recesses b.
Temporarily tighten the pad pin at this
G
point.
Install the brake hose holder 9 and cali-
G
per 0 and tighten the pad pin A.
NOTE:
Fit the brake hose holder cut c over the
projection d on the front fork and clamp the
brake hose.
Bolt (caliper):
23 Nm (2.3 m • kg, 17 ft • lb)
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)
INSP
ADJ
Publicidad
Capítulos
