Operating Instructions - Saladmaster L20210SA Manual De Instrucciones

7

Operating Instructions

1. Insert automatic heat control into appliance. Plug into electric
outlet. As soon as the appliance is plugged in, a red signal light will
appear on the right side of the display.
appliance at least 4" (10 cm) from wall.
2. To set the desired temperature, press and release the temperature
key (the default temperature will flash) then press the up or down
arrow until the desired temperature appears on the display. To select
the default temperature of 150°F (65°C), press the temperature key
a second time. If no temperature is set, the display will flash for 2
minutes and automatically shut off. Pulsing the up or down arrow
will adjust the temperature by 5-degree increments; pressing and
holding the key will adjust it by 25-degree increments (10-degrees
in Celsius). As the appliance preheats to desired temperature, the
signal light (red light on left side of digital display) will blink on and
off. Always preheat appliance (4 to 6 minutes), unless recipe states
to start with it cold.
3. Add food when the signal light stops blinking, indicating that the
cooking temperature has been reached. Heat may be increased
or decreased by depressing the up or down arrow, depending
upon the type or amount of food being prepared. The signal light
will cycle on and off during cooking to indicate that the proper
temperature is being maintained.
4. After the food is placed in the appliance, set the cooking time if
desired. Press and release the time key. The display will flash "00:00."
Press the up or down arrows until the desired length of time is set
(maximum is 12 hours). If no time is set, the heat control will operate
at the preset temperature until the off button is pressed. Pulsing
the key will adjust the time by 1-minute increments; pressing and
holding either key will adjust the time by 10-minute increments. The
time will automatically count down and the remaining time will be
displayed unless the temperature key is pressed. The temperature
or time can be changed or displayed anytime during cooking by
simply repeating the steps detailed above.
5. When cooking is complete, and the time setting has not been used, press
the off button. The temperature and time settings will be cancelled.
6. Pressing and holding both temperature and time buttons at the same
time will switch temperature reading between Fahrenheit and Celsius.
Healthy Cooking Guide
CAUTION: Always operate