WEG CLIC-02 Manual Del Usuario página 104

Ladder Logic Programming
On the CLIC02 display or in the programming tool, the Datalink function will be displayed
this way:
In the example below, variables I03~I07 will be written in the network variables controlled
by the CLIC-02. Since the selected address for this CLIC-02 is address 1, the network
variables used will be W09~W13.
Network Variables
Internal Variables
do CLIC-02
Each CLIC-02 can control 8 bits of network data. Therefore, only 1 Datalink function will
be used in the Send mode.
In the example below, the Datalink function will read the network variables W09 ~ W13
and write them in the internal variables M03 ~ M07. Since the function is configured to
read 5 variables, remaining addresses W22, W23 and W24 will not be read, not affecting
markers M08, M09 e M0A.
Network Variables
Internal Variables
of CLIC-02
104 | CLIC-02
④ ②⑤
 
W09 W10 W11
  
I03 I04 I05
W17 W18 W19
  
M03 M04 M05
- English -


①
 ⑥
W12 W13 W14
  
I06 I07 0
W20 W21 W22
  
M06 M07 -
W15 W16
 
0 0
W23 W24
 
- -