WEG CLIC-02 Manual Del Usuario página 181

2. Network Status LED (NS)
Dual color LED (green and red) indicates the status of the network busbar in which the
equipment is connected.
LED Status (NS)
Off Network with no supply
-The network master is disconnected
Green On Standard operating mode, slave
connected to the master
Flashing Green Standard operating mode, but not
connected to the master or to be
released
Flashing Red Connection Time out. Occurs after a
few seconds the Green Flashing LED.
Red On Error. Double Network ID
– Communication Error
11.4.3 Profibus
Summary
The CLIC-02/PBUS module is a network communication interface into Profibus DP. On
Profibus DP (network), CLIC-02/PBUS can only operate as a network slave.
Module CLIC-02/PBUS Configuration







Explanation
SW2 – Selection switch of the termination resistor
Supply 24Vdc
Supply LED (POW)
Communication LED (BUS)
Expansion Connection Port on CLIC-02
SW1 – Set of 8 switches to adjust the ID
9-pin PROFIBUS DP Connector
- English -
Expansion Modules
Fail Correction or Prevention
Turn on the network supply
– Connect the master to the network
-
-
-
Check if the module ID is on another
network device
– Check master configurations
CLIC-02 | 181