Initial Screen - WEG CLIC-02 Manual Del Usuario

Programming Tool
5.3 CONNECTING THE PROGRAMMING CABLE
Remove the plastic cover of the CLIC-02 connector using a screwdriver as shown in the
figure below. Insert the end of the plastic connector of the programming cable onto the
CLIC-02 and connect the opposite cable end to a RS232 serial port on the computer.

5.4 INITIAL SCREEN

When opening CLIC02 Edit programming software, the initial screen will be displayed. On
this screen the following functions may be performed:
New Ladder Program
Select File – New – New LAD to enter the development environment of a new Ladder
program.
New FBD Program
Select File – New – New FBD to enter the development environment of a new FBD
program (Function Block Diagram).
Open an Existing File
Select File – Open to select the type of file to be open (Ladder or FBD) and select the
desired program. Then click Open.
38 | CLIC-02 - English -