2. Now we are going to create a line linking the contact to an output. Use the "A" key on
your keyboard (or the icon "A" on the Ladder toolbar) to draw a horizontal circuit line,
which goes from contact M to the rightmost cell, as shown below.
3. Select icon "Q" of coil in the Ladder toolbar (or just press letter "Q" in the keyboard)
and drop it on the rightmost cell. Select Q01 in the checkbox and click OK as shown
below. See Chapter 7: Programming in Ladder Logic for complete definitions of the
instructions set.
- English -
Quick Programming Guide
CLIC-02 23