WEG CLIC-02 Manual Del Usuario página 179

Configuration of the Module CLIC-02/DNET
Supply 24Vdc

Network Status LED

Module Status LED

5-pin DeviceNet port

Release Button

Expansion Connection Port

SW1 – Set of 8 switches to adjust the communication ID and BaudRate

SW2 – Selection switch of the termination resistor

Retractable Mounting Piece

Connection with the DeviceNet network
Using a 5-pin connector, connect the CLIC-02/DNET to the DeviceNet busbar. Please
use a cable in accordance with the
the maximum cable length and the network transmission rate.
Port Signals
ODVA requirements. The cable features will influence
1 GND black
2 CAN_L blue
3 Shield uncolored
4 CAN_H white
5 24V red
- English -
Expansion Modules
CLIC-02 | 179