Once the basic unit is installed, fit in the expansion onto the bus of the basic unit - the top
button of the expansion should be pressed to release this fitting. Fix the screws on the
expansion unit.
The uninstall process is the opposite mode. First, release the expansion screw, then press
the expansion button to disconnect it from the basic unit. Finally, release the screw on the
base unit to remove it.
4.4 ELECTRICAL WIRING DIAGRAMS
WARNING!
The I/O cables must not be fixed in parallel to power wiring or placed in the
same channel.
ATTENTION!
To prevent possible short circuits, it is recommended to install a fuse between
the output terminal and the load.
4.4.1 Cable Size and Torque on the Terminal
2
mm
AWG
(0.14in)
0.14...1.5
0.14...0.75
26...16
26...18
3.5
C
- English -
0.14...2.5
0.14...2.5
26...14
26...14
C
Nm
lb-in
Installation
M4 x 20 (#8 x 32)
0.14...1.5
26...16
0.6
5.4
CLIC-02 | 33