Memory Card - WEG CLIC-02 Manual Del Usuario

9.6 MEMORY CARD

The memory card PM05 (3rd) is an optional item sold separately which is used to transfer
programs easily from one to another CLIC-02. The memory cartridge PM05 (3rd) must be
inserted in the same programming cable connector (see procedure below).
1. Remove the CLIC-02 plastic connector cover using a screwdriver;
2. Insert the memory cartridge PM05 (3rd) in the connector;
3. In the list of functions of the display, select WRITE, to transfer the CLIC-02 program to
PM05 (3rd), or READ, to load the PM05 (3rd) program to CLIC-02.
4. Programs in different CLIC-02 models are not compatible in some cases, in accordance
with the rules:
A-1: Program CLIC-02 10/12 points ---- compatible with CLIC-02 20 points
A-2: Program CLIC-02 20 points ---- non-compatible with CLIC-02 10/12 points
B-1: Program CLIC-02 AC ---- compatible with CLIC-02 DC
B-2: Program CLIC-02 DC ---- non-compatible with CLIC-02 AC
C-1: Program CLIC-02 to Relay — compatible with Transistor CLIC-02
C-2: Program CLIC-02 to Transistor — non-compatible with Relay CLIC-02
D-1: Program CLIC-02 different from type V — compatible with CLIC-02 with type V
D-2: Program CLIC-02 type V — non-compatible with CLIC-02 different from type V
E-1: Program CLIC-02 firmware V2.xx ---- compatible with CLIC-02 V3.xx
E-2: Program CLIC-02 firmware V3.xx ---- non-compatible with CLIC-02 V2.xx
9.6.1 Compatibility
The memory card PM05 (3rd) is a special type of PM05 that can be used in alll versions of
CLIC-02. There is an icon
with CLICK-02 V2.xx and CLIC-02 V3.xx, see the function compatibility table:
CLIC-02 Firmware Version
CLIC-02 V2.xx
CLIC-02 V3.xx
; in the side of PM05 (3rd).To use PM05 and PM05 (3rd)
Supported Function
PM05
Reading/Writing
Reading
- English -
Hardware Specification
PM05 (3rd)
Reading/Writing
Reading/Writing
CLIC-02 | 147