Orbitalum ORBIMAT 300 SW Traduccion Del Manual De Instrucciones Originales página 107

EnGLISH
ORBIMAT 300 SW
Abb. 6: Machine ready to start – Welding (left) Abb. 7: Machine ready to start – Test run (right) – Start
X To change between the welding mode and the test mode the yellow "GAS" button at the weld head remote control
or at the handle of the weld head can be activated by pressing it and keeping it pressed for 3 seconds.
With the remote control of the weld head:
X Press the gray "Motor" button until the desired position is reached. Only one rotation direction is possible here.
With an additional remote control (optional, available as accessory):
X Press the "MOTOR+" or "MOTOR –" button.
The rotor turns in the selected direction as long as a button is being pressed.
With the push switches of the machine:
X Call up main menu, if necessary.
X Press softkey 2 "Test".
The main menu in test mode appears in the display, and the "Start" button is yellow.
X Press softkey 4 "Motor".
The assignment of the softkeys for controlling the motor changes.
X Press "Motor forward" or "Motor backward" button.
The motor runs in the selected direction as long as the button is being pressed.
X Press softkey "Home".
The weld head turns to the open position.
X Press softkey "Motor OK" to exit the operating scheme.
X Press softkey 5 "Menu" to change directly to the main menu.
(14.01.21) OW_ORBIMAT_300SW_BA _852060202_00_EN ORBITALUM TOOLS GMBH, D-78224 SINGEN, W W W.ORBITALUM.COM, PHONE +49 (0) 77 31 792-0 107