Calling Up A Procedure; Locking Machine With A Login - Orbitalum ORBIMAT 300 SW Traduccion Del Manual De Instrucciones Originales

EnGLISH
If "New folder" was pressed:
3. Select the input field and briefly press the rotary knob.
4. The input field is activated.
5. Enter the folder name with the keyboard.
6. Press the OK" button.
The new folder is created.
7. Select the new folder.
8. Highlight and activate the input field for procedure names and enter the new procedure name.
9. Press the OK" button.
The procedure is saved with the new name (possibly in newly created folder).
8.4.2

Calling up a procedure

X Recommendation: Save unsaved procedures if necessary before calling up a procedure.
1. Press the "Select procedure" button in the main menu.
2. Select the folder.
A list of procedures is displayed. Additional information on each procedure appears in the display.
3. Select the procedure.
If an unsaved procedure is loaded in the RAM, another procedure cannot be loaded. A warning is
displayed:
"Cancel": The procedure call is cancelled. The main menu appears.
"No": The unsaved procedure is not saved, and any adjustments made are lost. The selected proce-
dure is called up.
"Yes": The unsaved procedure is saved. The main menu appears.
If unsaved procedures are saved or adjustments were rejected:
4. Call up the procedure again.
The selected program appears in the display.
8.5

Locking machine with a login

The machine disposes of two views of the main menu:
Long form
Procedure programming mode. Procedures can be changed, and sensors and monitoring functions can be activated/deacti-
vated.
Short form
Production mode. All functions which lead to changes in the existing procedures cannot be executed in the "Short menu"
and are not displayed. Sensors and monitoring functions cannot be deactivated.
120
orbitalum tools GmbH, D-78224 Singen, www.orbitalum.com, Phone +49 (0) 77 31 792-0
ORBIMAT 300 SW
(14.01.21) OW_ORBIMAT_300SW_BA_852060202_00_EN