ORBIMAT 300 SW
4.1.4
ORBmax oxygen meter
For optical oxygen measurement using fluorescence extinction.
The ORBmax does not require any heating-up time. It recognizes the oxygen percent-
age reliably, rapidly and precisely during the entire welding process.
4.1.5
Remote control with cable
For transferring all the commands important for welding to the power source.
It is not required when working with enclosed orbital weld heads.
4.1.6
OCL-30 coolant
Anti-freeze pre-mix for ORBIMAT power sources and cooling units to avoid freezing of
the cooling water. Protects up to –30 °C (–22°F) outside temperature. Increased ser-
vice life of components of the cooling system through very high corrosion protection
and high pH-value. Excellent ignition characteristics due to low conductivity. Clear
cooling liquid.
4.1.7
ORBIPURGE forming set
For rapid and efficient internal forming during pipe and molded part weld connections
while at the same time reducing gas consumptions.
4.1.8
Paper rolls and ribbon cartridges
For internal system printer.
Suitable for all ORBIMAT orbital welding power supplies.
(14.01.21) OW_ORBIMAT_300SW_BA _852060202_00_EN
ORBITALUM TOOLS GMBH, D-78224 SINGEN, W W W.ORBITALUM.COM, PHONE +49 (0) 77 31 792-0
EnGLISH
95