Adjusting The Procedure; Reasons And Steps For Adjusting Procedure; Making Percental Changes - Orbitalum ORBIMAT 300 SW Traduccion Del Manual De Instrucciones Originales

ORBIMAT 300 SW
8.3

Adjusting the procedure

8.3.1

Reasons and steps for adjusting procedure

The auto programming of the machine cannot take all influencing factors into account during welding. Procedures can
be adjusted after the test run for this reason.
Possible reasons are:
• Batch-dependent fluctuations in the material composition.
• Different dissipations (pipe on solid parts) etc. For example due to components with different sizes.
X Improve the procedure step by step. When adjusting, change only one parameter at a time so that you can better
judge the influence on welding.
X Save the adjusted procedure.
X After the adjustment, carry out a test run of the parameters.
X Observe the effects of the adjustment and carry out further adjustments if necessary.
8.3.2

Making percental changes

Reason: Welding result even, but weld seam penetrated too lightly or too strongly.
The percentage change affects all levels (sectors) on high- and low-pulse current.
After the test run, the "Scale weld" field is highlighted in the display.
1. Highlight a field.
2. Adjust and save the value with the rotary knob or keyboard:
Positive value: Increase the weld current.
Negative value: Reduce the weld current.
The settable value range can be limited in the procedure (for example only max. +5% and min. –5%).
Changing the scale weld
Abb. 9: Scale weld limit
(14.01.21) OW_ORBIMAT_300SW_BA _852060202_00_EN
1. In the main menu, select "System settings" > "Pro-
gram settings".
The current limit within which the operator can change
the scale weld in "completed" mode (production mode) is
specified in the "Scale weld limit" field.
Example: Specification "5%" – Change in range from –5%
to +5% (absolute range: 10%).
2. Adjust and save the value with rotary knob or key-
board.
ORBITALUM TOOLS GMBH, D-78224 SINGEN, W W W.ORBITALUM.COM, PHONE +49 (0) 77 31 792-0 111
EnGLISH