Tig Manual Welding Torch - Orbitalum ORBIMAT 300 SW Traduccion Del Manual De Instrucciones Originales

ORBIMAT 300 SW
Connecting the unit
1. Connect the unit to the "BUP Control" connection socket of the machine.
2. In the main menu select "System settings" > "System adjustments".
3. Select the "Yes" option for "External input for abort".
The signal from the oxygen meter is monitored continuously.
To save the activation of the external input in a procedure:
X Save the procedure after activation.
Activating the unit
1. In the main menu select "Manual/Adjust programming" > "Adjust parameters" > "Gas settings".
2. Select the "Yes" option for "Backup gas control".
The parameters required for programming the BUP unit are enabled.
Programming the values and reference values for the individual parameters
See the operating instructions for the supplementary unit.
8.8.3

TIG manual welding torch

Liquid-cooled manual welding torches with the Orbitalum connection system can be connected.
The torch should have a torch button for starting the process.
• For cassette weld heads: Ground wire required.
• For LP heads: The optional ground wire can also be used in conjunction with the manual welding torch.
Procedures can be adjusted and saved for manual operation.
Functions in manual operation:
Torch button on manual torch
The torch button functions in four-cycle operation:
• Start process by pressing the button.
• During the welding process, press the torch button again and hold it down: The machine carries out the final slope-
off for the programmed time and as long as the torch button is pressed. When the final current is reached, the
machine ends welding automatically.
• Release the torch button while slope-off is active: The process is interrupted (used, for example, to set a tack point
without having to wait for the entire slope-off time to pass).
Weld current and pulse times
As programmed in sector 1: The machine remains in sector 1 during the entire manual welding procedure; any pro-
grammed sector times and rotation angles are meaningless.
Gas pre purge, ignition current, slope-off and gas post purge:
As programmed.
Sensors for gas and coolant monitoring:
Active during manual operation, weld current is monitored.
Speed monitoring:
Deactivated; programmed weld speeds are meaningless.
(14.01.21) OW_ORBIMAT_300SW_BA _852060202_00_EN ORBITALUM TOOLS GMBH, D-78224 SINGEN, W W W.ORBITALUM.COM, PHONE +49 (0) 77 31 792-0 125
EnGLISH