Setting The Language; Setting The Measuring Units - Orbitalum ORBIMAT 300 SW Traduccion Del Manual De Instrucciones Originales

EnGLISH
Is an external remote control not connected?
The dummy plug is missing from the remote control connection, EMERGENCY-STOP is activated.
X Insert dummy plug to close the EMERGENCY-STOP circuit if necessary.
7.5.3

Setting the language

The factory setting for the system language is "German".
Changing the language:
1. In the main menu call up the menu item "System
settings" by turning the rotary knob and confirm by
pressing.
2. Subsequently call up the menu item "Language".
3. Select the desired language and confirm with the
rotary knob.
7.5.4

Setting the measuring units

The operating system can be set to "Metric" or "Imperial" measuring units.
The factory setting is "Metric".
Changing the measuring unit:
1. In the main menu call up the menu item "System
settings" by turning the rotary knob and confirm by
pressing.
2. Subsequently call up the menu item "System adjust-
ments".
3. Use the rotary knob to select the desired measuring
unit under "Imperial sizes" by selecting "Yes/No" and
confirm.
The ORBIMAT is now ready to operate.
102
orbitalum tools GmbH, D-78224 Singen, www.orbitalum.com, Phone +49 (0) 77 31 792-0
Abb. 1: Setting the language
Abb. 2: Setting the measuring unit
(14.01.21) OW_ORBIMAT_300SW_BA_852060202_00_EN
ORBIMAT 300 SW