Adjusting An External Printer; Switching On An Internal Printer - Orbitalum ORBIMAT 300 SW Traduccion Del Manual De Instrucciones Originales

ORBIMAT 300 SW
9.1.3

Adjusting an external printer

Adjust the printing of data when using an external (A4) printer.
Example: Printing data on letter paper.
1. Press the "External printer setup" button.
The following display appears:
Abb. 28: Printer – Settings (external)
9.1.4

Switching on an internal printer

Inserting a new paper roll
This function is used exclusively to insert a new paper roll in the internal printer.
1. Switch on the "Internal printer on" button.
The button for the is activated.
2. Open the printer hood and cover of the printer.
3. Remove the empty cardboard roll with the shaft. Remove any paper still
present in the printer by pressing the button on the printer (line feed). Do
not pull on the paper here!
4. Slide a new paper roll onto the shaft and insert it into the recess of the
housing provided for holding the shaft until the shaft latches in audibly.
Put the paper roll on in such a manner that the paper rolls off to the back.
Put on the shaft as shown on the label in the paper compartment.
5. Cut off paper start straight and insert it into the printing unit.
6. Move paper forward by pressing the line feed button.
D not pull the paper through by hand!
7. Guide the paper through the slot in the cover and close the cover again.
(14.01.21) OW_ORBIMAT_300SW_BA _852060202_00_EN
2. Select and highlight fields and enter the desired
values.
ORBITALUM TOOLS GMBH, D-78224 SINGEN, W W W.ORBITALUM.COM, PHONE +49 (0) 77 31 792-0 139
EnGLISH