Check Sensors On The Input Module - Aventics CANopen Instrucciones De Servicio

126 AVENTICS | CANopen | R412005742–BDL–001–AD
Commissioning and operation
Table 20: Definitions for diagnostic LEDs on the bus coupler (cont.)
LED Signal
Flashes red++
Flashes red+++
1)
This display appears only as long as the overloaded output is controlled or as long as the total current
of the sensor supply is exceeded.
3)
Flashes green~
4)
Flashes red~~/flashes green~~
5)
Flashes red+/flashes green+
6)
Flashes red++
7)
Flashes red+++
Description
5)
Module is in
A heartbeat/monitoring event has occurred.
Condition: Object 1006 supported.
6
) Module is in a
configured time.
Slow flashing of the display: 0.2 s on/0.2 s off
Fast flashing of the display: 0.05 s on/0.05 s off
Flashing of the display: 0.2 s on/1 s off
2x flashing: 0.2 s on/0.2 s off; 0.2 s on/1 s off
3x flashing: 0.2 s on/0.2 s off; 0.2 s on/0.2 s off;
0.2 s on/1 s
7.5.2
There is one LED per input on the input module for monitoring
purposes. The LED lights up if the signal level is high.
Before commissioning the system, check the sensor
O
function and method of operation by reading the LEDs.
Fig. 11: LED displays on the M8 input module (left) and M12 (right)
Table 21:
LED
Input
"
error control event
" "
sync error state. SYNC message was not sent within
2
off

Check sensors on the input module

LED display on the input modules
Color
Yellow
"
state.
Meaning
High signal level mode