Steering Friction [Tiller Handle Type Only] - Honda Motor BF40D Manual Del Usuario

13. STEERING FRICTION
[TILLER HANDLE TYPE ONLY]
1
Inspection/Adjustment:
2
1) Set the steering friction lever in the lock position (i.e. where
the lever comes in contact with the stopper by turning it
3
fully to the left).
4
5
6
2) Holding the steering friction lever locked, apply 98 N (10.0
kgf) of load to the center of the tiller handle throttle grip
7
and check that the outboard motor does not turn.
8
9
10
11
12
13
14
15
16
17
18
19
3) If the outboard motor turns, set the steering friction lever in
the lock position and tighten the 8 mm self-locking nut to
20
the specified torque.
TORQUE: 9.5 N . m (1.0 kgf . m, 7 lbf . ft)
4) If the outboard motor still turns after tightening the 8 mm
self-locking nut to the specified torque, check the disc of the
friction block for wear or contamination with grease.
Replace the friction block if necessary (P. 16-3).
3-26
[1]
STEERING
FRICTION LEVER
[1]
Apply 98 N (10.0 kgf)
of load.
[1]
STEERING
FRICTION LEVER
386
[2]
STOPPER
[3]
Lever must be in
contact with the
stopper.
[2]
THROTTLE
GRIP
[3]
[2]
8 mm SELF-
STOPPER
LOCKING NUT
[4]
Lever must be in
contact with the
stopper.