Honda Motor BF40D Manual Del Usuario página 788

f. INSTALLATION
1) Install the two vapor separator grommets and the two
collars.
2) Set the vapor separator assembly and tighten the two 6 x
25 mm bolt/washers securely.
3) Connect the pressure regulator control tube to the pressure
regulator.
4) Install the air vent tube clamp on the pressure regulator
control tube.
5) Connect the fuel pump 2P connector.
6) Connect the air vent tube A, air vent tube B and the fuel
tube C to the vapor separator.
Install the tube clip B12 with the tab in the direction shown.
5-110
[1]
VAPOR SEPARATOR
GROMMET (2)
[4]
COLLAR (2)
[2]
PRESSURE REGULATOR
CONTROL TUBE
[1]
AIR VENT
TUBE B
[9]
FUEL TUBE C
[8]
TUBE CLIP B12 (3)
[7]
AIR VENT TUBE
CLAMP
788
[2]
VAPOR SEPARATOR
ASSEMBLY
[3]
6 x 25 mm
BOLT/WASHER
[3]
PRESSURE
REGULATOR
[4]
AIR VENT
TUBE A
[5]
VAPOR
SEPARATOR
[6]
FUEL PUMP 2P
CONNECTOR