Honda Motor BF40D Manual Del Usuario página 830

9) Secure the power tilt relay ground cable with the 6 x 12 mm
flange bolt while pushing it against the projection [Power
trim/tilt type only].
1
10) Set the alternator stator wire, main wire harness and the
2
power tilt relay ground cable [Power trim/tilt type only] in
the wire harness clip.
3
11) Connect the power tilt relay 2P connector and install the
connector on the harness clip bracket A [Power trim/tilt
4
type only].
5
6
7
8
9
10
11
12
12) Route the trim angle sensor wire between the main wire
13
harness and the electric part case while pulling the main
wire harness toward you [Power trim/tilt type only].
14
13) Set the trim angle sensor wire in each clamp of the electric
15
part case, and connect the trim angle sensor 3P connector
[Power trim/tilt type only].
16
17
18
19
20
6-11
[2]
POWER TILT RELAY 2P CONNECTOR
[1]
WIRE HARNESS CLIP
[6]
HARNESS
CLIP
[5]
BRACKET A
ALTERNATOR
STATOR WIRE
[7]
PROJECTION
[1]
TRIM ANGLE SENSOR
3P CONNECTOR
[5]
CLAMPS
[4]
MAIN WIRE HARNESS
830
[3]
POWER TILT RELAY
GROUND CABLE
6 x 12
[4]
MAIN WIRE
HARNESS
[2]
ELECTRIC PART
CASE
[3]
TRIM ANGLE
SENSOR WIRE