Honda Motor BF40D Manual Del Usuario página 808

21. EBT (ENGINE BLOCK
TEMPERATURE) SENSOR
• REPLACEMENT
1) Remove the engine cover (P. 4-2).
2) Disconnect the EBT sensor 2P connector and remove the
EBT sensor.
3) Remove the O-ring from the EBT sensor.
4) Apply engine oil to the new O-ring and install it on the new
EBT sensor.
5) Install the new EBT sensor and tighten it to the specified
torque.
TORQUE: 18 N . m (1.8 kgf . m, 13 lbf . ft)
6) Connect the EBT sensor 2P connector.
7) Install the engine cover (P. 4-2).
5-120
[1]
O-RING
[3]
EBT SENSOR 2P
CONNECTOR
808
[2]
EBT SENSOR