Honda Motor BF40D Manual Del Usuario página 782

7) Connect the red terminal and the black terminal as shown
and install the cover.
8) Install the fuel pump (high pressure side) on the insulator.
9) Align the projection on the pump cover with the groove in
the pump holder.
10) Set the pump holder so the two projections on the pump
holder are in the positions shown and tighten the three 5
mm screw washers securely.
5-107
[1]
INSULATOR
[5]
RED TERMINAL
[4]
FUEL PUMP
(HIGH PRESSURE SIDE)
[1]
PUMP HOLDER
[4]
PROJECTION
[5]
PUMP COVER
782
[2]
COVER
[3]
BLACK
TERMINAL
[2]
5 mm SCREW
WASHER (3)
[3]
GROOVE
[4]
PROJECTION