Motores; Replacing The Axis-1 Motor - ABB IRB 5720 Manual Del Producto

5 Reparación

5.8.1 Replacing the axis-1 motor

5.8 Motores

5.8.1 Replacing the axis-1 motor
Replacing the motor on an inverted manipulator
To replace the motor on an inverted manipulator, the axis-1 gearbox must be
drained and a special lifting accessory must be used, according to the procedures
in this section.
The alternative is to lift down the manipulator to floor-standing, see
manipulador desde la posición invertida hasta la posición en el suelo en la
página
Location of the motor
The motor is located as shown in the figure.
xx2000000241
Summary of the replacement procedure
This list is a brief summary of the replacement procedure, containing the major
actions to be performed.
Continúa en la página siguiente
320
197.
1 If installed in an inverted position (option 3317-1): drain the axis-1 gearbox.
2 Replace the motor.
© Copyright 2022 ABB. Reservados todos los derechos.
Bajar el
Manual del producto - IRB 5720
3HAC079195-005 Revisión: A