GreenWorks Tools 1300607 Manual De Utilización página 23

EN
DE
FR DE ES IT PT
FR EN ES IT PT
ASSEMBLY (POLE HEDGE TRIMMER)
FITTING AND REMOVING THE TRIMMER HEAD
(FIG.K)
FITTING THE TRIMMER HEAD
Align the arrow on the end of main handle (27 ) with
the arrow on the trimmer head (28).
Push the trimmer head (28) onto the handle (27) till
the red line.
Fasten the trimmer head cam lock.
WARNING
Periodically check the connections to ensure that
they are tightened securely.
REMOVING THE TRIMMER HEAD
Rest the handle (27) on the ground, loosen the trimmer
head cam lock and push lock button, then take off the
trimmer head (28).
ADJUSTING THE TRIMMER HEAD ANGLE (FIG.L)
The trimmer head pivots 105° and can be locked into 7
positions within that range.
WARNING
To avoid being pinched, wear gloves and hold the unit
as shown.
TELESCOPING THE HANDLE (FIG.N)
Rest the handle (27) on the ground.
Loosen the handle cam lock and adjust thehandle
shaft to a comfortable length.
Fasten the handle cam lock.
FITTING AND REMOVING THE BATTERY (FIG.J)
To fit the battery (31), line it up with the receptacle
on the tool. Slide the battery into the receptacle and
push until the battery snaps into place.
To remove the battery, push the release button
while at the same time pulling the battery out of the
receptacle.
NL SV DA NO FI HU CS RU RO PL
NL SV DA NO FI HU CS RU RO PL
English (original instructions)
CHARGING THE BATTERY (FIG. A)
The battery needs to be changed before first use and
whenever it fails to produce sufficient power on jobs that
were easily done before.The battery may become warm
while charging; this is normal and does not indicate a
problem.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10°C or above
40°C. The battery should be left in the charger and the
charger will begin to charge automatically when the cell
temperature warms up or cools down.
OPERATE THE POLE SAW
For your safety, this tool is equipped with a double
switching system. This system prevents starting the tool
inadvertently.
Switching on
Switching off
Pruning (fig.F)
16
SL HR ET
SL HR ET
OPERATION
WARNING
Let the tool work at its own pace. Do not overload.
WARNING
Do not charge the battery at ambient temperatures
below 10°C or above 4 0°C. Recommended charging
temperature: approx. 24°C.
Push the lock-off button (2) backward using your
thumb and at the same time squeeze the on/off
switch (1).
Release the lock-off button (2).
Release the on/off switch (1).
WARNING
Never attempt to lock a switch in the on position.
Make sure the tool is running at full speed before
making a cut.
Hold the tool firmly in place to avoid possible
bouncing or sideways movement of the tool.
Guide the tool through the branch using light
pressure. When cutting heavy branches, where a
partial cut may splinter and damage the tree, proceed
as follows:
Make the first cut 15cm from the tree trunk on the
underside of the limb. Use the top of the guide bar (6)
to make this cut.
Cut one third through the diameter of the limb. Then
LT LV SK BG
LT LV SK BG