GreenWorks Tools 1300607 Manual De Utilización página 26

EN
DE
FR DE ES IT PT
FR EN ES IT PT
TROUBLESHOOTING
POLE HEDGE TRIMMER
Fault Possible
Tool will Battery not
not start installed properly
Battery discharged
ŹÁ Å ¸ËÊÊÅÄ
not actuated
Pole connections
not properly
tightened
Battery Battery not
will not installed properly
charge
POLE SAW
Fault Possible
Bar and Check chain
chain tension
running hot for overtightened
and condition.
smoking. Bar lube
reservoir
empty.
Motor runs, Chain tension
but too tight.
chain is not Check guide bar
rotating. and
chain assembly.
Check guide bar
and
chain for
damage.
NL SV DA NO FI HU CS RU RO PL
NL SV DA NO FI HU CS RU RO PL
English (original instructions)
Action
Check the battery
installation
Fit a (fully) charged
battery
Observe the starting
procedure
Check the
connections
Check the battery
installation
Action
Tension chain.
Refer to Chain
Tension earlier in
this manual.
Check bar lube
reservoir.
Retention chain.
Refer
to Chain Tension
earlier
in this manual.
Refer to Replacing
the
Bar and Chain
earlier in
this manual.
Inspect guide
bar and chain for
damage.
19
SL HR ET LT LV SK BG
SL HR ET LT LV SK BG