Publicidad
6. VERTICAL SHAFT/BEVEL GEAR
1
a. DISASSEMBLY
Remove the following parts.
- Propeller (P. 11-2)
2
- Gear case assembly (P. 11-3)
- Propeller shaft holder assembly (P. 11-7)
3
- Water pump/shift rod (P. 11-19)
1) Attach the special tool to the end (primary driven gear
4
installation side) of the vertical shaft.
TOOL:
5
Vertical shaft holder
6
2) Place a shop towel or equivalent material as shown to
protect the gear case.
7
3) Holding the vertical shaft with the special tool, remove the
12 mm special flange nut and remove the pinion gear from
8
the vertical shaft.
9
10
11
12
4) Remove the vertical shaft assembly from the gear case
13
assembly.
14
5) Remove the water bottom tube and the rubber set plate
from the gear case assembly.
15
16
17
18
19
20
11-29
[2]
VERTICAL SHAFT HOLDER
07LPB-ZV30200
07LPB-ZV30200
[3]
PINION
GEAR
[6]
GEAR CASE
[1]
VERTICAL SHAFT
ASSEMBLY
[4]
GEAR CASE
ASSEMBLY
278
[1]
VERTICAL SHAFT
[4]
12 mm SPECIAL
FLANGE NUT
[5]
SHOP
TOWEL
[2]
WATER BOTTOM
TUBE
[3]
RUBBER SET
PLATE
Publicidad
Capítulos
