Publicidad
4) Apply ATF to a new O-ring and install it on the power tilt
motor.
1
Install the power tilt motor aligning the projection on the
motor shaft with the groove in the drive joint.
2
• Install with the power tilt motor wire toward the oil filler
port of the oil tank.
3
4
5
6
7
8
9
10
11
12
5) Tighten the four screw washers to the specified torque.
13
• Install and tighten the motor wire bracket A in the
14
position shown.
15
TORQUE: 5.9 N . m (0.6 kgf . m, 4.4 lbf . ft)
16
17
18
19
20
14-52
[1]
OIL FILLER PORT
[4]
POWER TILT
MOTOR WIRE
[1] SCREW WASHER
[2]
MOTOR WIRE
BRACKET A
522
[2]
PROJECTION ON
MOTOR SHAFT
[3]
GROOVE IN DRIVE
JOINT
Publicidad
Capítulos
