Publicidad
8) Set the trim tab aligning the "
the "
" mark on the gear case assembly, and tighten the 8
mm washer and 8 x 20 mm hex bolt securely.
1
2
3
4
5
6
9) Move the shift to the "R" (Reverse) position and push the
shift rod B of the gear case assembly down to the
7
lowermost position (Reverse position).
8
10) Turn the lock nut right or left to adjust the distance from the
lock nut end to the end of shift rod B to 8 mm or more as
9
shown.
11) Turn the shift rod joint nut to align the bottom end of the
10
shift rod A with the bottom end of the shift rod joint nut.
11
12) Tighten the shift rod joint nut up to the lock nut position of
the shift rod B and tighten the lock nut securely.
12
After installation, move the shift to the "N" (Neutral)
position. Check whether the shift moves smoothly.
13
• Be sure to tighten the shift rod joint nut against the shift
rod B with the shift and the shift rod B in the "R" (Reverse)
14
position.
15
13) Adjust the shift cable (P. 3-20).
16
17
18
19
20
11-6
" mark on the trim tab with
232
[1]
8 x 20 mm
HEX BOLT
[3]
TRIM TAB
[2]
[1]
SHIFT ROD
SHIFT ROD A
JOINT NUT
[6]
8 mm or
more
[4]
[5]
LOCK NUT
SHIFT ROD B
[3]
Align the end of the shift
rod A with the end of the
shift rod joint nut.
[2]
"
" MARKS
Publicidad
Capítulos
