Inspection - Honda BF40D Manual De Instrucciones

2. INSPECTION

1 • PISTON SKIRT O.D.
1) Check the piston outer surface for damage (scores,
scratches, etc.). Check the piston for warpage and cracks.
2
2) Measure and record the piston O.D. at 10 mm (0.4 in) from
3
the bottom and at right angles to the piston pin bore.
4
Standard
69.970 - 69.990 mm
5
(2.7547 - 2.7555 in)
6
3) If the measurement is less than the service limit, replace
the piston with a new one.
7
8
9
10
11
12
• CYLINDER SLEEVE I.D.
13
1) Check the inner wall of the cylinder for damage (scores,
scratches, etc.).
14
2) Measure and record the cylinder I.D. at three levels in both
15
X and Y axes. Take the maximum reading to determine the
cylinder I.D.
16
Standard
17
70.000 - 70.015 mm
(2.7559 - 2.7565 in)
18
3) If the measurement exceeds the service limit, replace the
cylinder block with a new one.
19
• PISTON-TO-CYLINDER CLEARANCE
20
Determine the difference between the piston skirt O.D. and the
cylinder sleeve I.D.
Standard
0.010 - 0.045 mm
(0.0004 - 0.0018 in)
If the measurement exceeds the service limit, replace the
cylinder block with a new one.
10-10
10 mm
(0.4 in)
Service limit
69.910 mm
(2.7524 in)
Service limit
70.060 mm
(2.7583 in)
Service limit
0.090 mm
(0.0035 in)
182
[1] O.D.
o
90
[1]
TOP
[2]
[3]
MIDDLE
BOTTOM
[1]
TOP
X
Y
[2]
[3]
MIDDLE
BOTTOM