Publicidad
35) Install the alternator rotor on the crankshaft, and loosely
tighten the 24 mm special nut.
1
• Note that the alternator rotor has very strong magnetic
force. Do not hold the alternator rotor by the ring gear but
2
hold it by the recoil starter rope winding area not to pinch
your fingers with the rotor.
3
4
5
6
7
8
36) Tighten the 24 mm special nut to the specified torque using
9
the special tool as shown.
TOOL:
10
Ring gear holder
11
TORQUE: 300 N . m (30.6 kgf . m, 221 lbf . ft)
12
13
14
15
16
17
37) Install the timing belt tensioner cap on the timing belt
tensioner.
18
38) Install the engine hanger on the cylinder block and tighten
19
the two 8 x 18 mm flange bolts securely.
20
39) Perform timing belt tension adjustment (P. 3-24).
40) Install the following parts.
- Electric part cover (P. 18-19)
- Alternator cover (P. 7-2)
- Engine cover (P. 4-2)
7-21
[2]
24 mm SPECIAL NUT
[1]
ALTERNATOR
ROTOR
07LPB-ZV30100
[2]
TIMING BELT
TENSIONER CAP
[1]
TIMING BELT
TENSIONER
58
[3]
CRANKSHAFT
[1]
RING GEAR HOLDER
07LPB-ZV30100
8 x 18 (2)
[3]
ENGINE
HANGER
Publicidad
Capítulos
