Publicidad
5) Open the wire harness clip and release the trim angle
sensor wire and the power tilt motor wire.
6) Pull the power tilt motor wire and the trim angle sensor
wire out of the hole in the L. stern bracket.
7) Remove the motor wire bushing and the wire harness clip.
8) Remove the two 6 x 20 mm flange bolts and remove the
trim angle sensor.
13-7
[1]
WIRE HARNESS CLIP
[5]
TRIM ANGLE
SENSOR WIRE
[1]
TRIM ANGLE
SENSOR
360
[2]
L. STERN
BRACKET
[3]
MOTOR WIRE
BUSHING
[4]
POWER TILT
MOTOR WIRE
6 x 20 (2)
Publicidad
Capítulos
