Publicidad
4) Remove the adjusting rod.
5) Remove the two 6 x 23 mm flange bolts, and remove the
1
anode metal.
2
Check the anode metal. Replace the anode metal with a
new one on reassembly if it is corroded excessively.
3
Loosen the 6 x 8 mm screw and remove the 116 mm lead
wire.
4
6) Loosen the 10 mm self-locking nut, and remove the 10 mm
5
washer and the 10 x 158 mm hex bolt.
6
7
8
9
10
11
12
7) Remove the tilting bolt cap.
13
Holding the 7/8-14 UNF self-locking nut on the R. stern
14
bracket side, loosen the 7/8-14 UNF self-locking nut on the
L. stern bracket side.
15
• Loosen the 7/8-14 UNF self-locking nut with care not to let
16
it come out of the tilting shaft.
17
18
19
20
14-55
[3]
10 x 158 mm
HEX BOLT
[2]
ANODE METAL
[1]
116 mm
LEAD
WIRE
6 x 23 (2)
[7]
10 mm SELF-
LOCKING NUT
[1]
L. STERN
BRACKET
528
[4]
ADJUSTING ROD
[5]
6 x 8 mm
SCREW
[6]
10 mm WASHER
[2]
TILTING BOLT CAP
[3]
7/8-14 UNF SELF-
LOCKING NUT
Publicidad
Capítulos
