Publicidad
14) Remove the cylinder comp. from the vise.
15) Remove the piston rod comp., and drain the ATF
1
(automatic transmission fluid) from the cylinder comp. in a
suitable container.
2
16) Remove the O-ring from the bottom piece.
Replace the O-ring with a new one on reassembly.
3
4
5
6
7
8
9
10
11
12
17) Hold the bottom piece of the piston rod comp. in a vise
13
using a shop towel or equivalent material as shown, and
loosen the outer tube using the special tool.
14
TOOL:
15
Lock nut wrench, 30 x 40 mm
16
Remove the piston rod comp. from the vise.
NOTICE
17
Do not tighten the vise excessively, as it can damage the
bottom piece.
18
19
20
14-12
[1]
PISTON ROD COMP.
[4] BOTTOM
PIECE
[1]
LOCK NUT WRENCH,
30 x 40 mm
07916-9690000
07916-9690000
[2] OUTER TUBE
[3]
BOTTOM PIECE
442
[2]
CYLINDER
COMP.
[3] O-RING
Publicidad
Capítulos
