Publicidad
f. INSTALLATION
1) Set the cylinder comp. in a vise.
1
NOTICE
Do not tighten the vise excessively, as it can damage the
2
cylinder comp.
2) Install the drive joint in the gear pump assembly in the
3
position shown.
4
5
6
7
8
9
10
11
12
13
14
15
16
17
3) Pour the ATF into the gear pump chamber of the cylinder
comp. until it flows out.
18
NOTICE
19
After pouring the ATF, check the ATF in the gear pump
chamber for bubbles. If the ATF contains bubbles, remove
20
them using an oil bottle or equivalent tool. Note that the
bubbles in the ATF will cause air in the system.
After removing the bubbles, fill the gear pump chamber
with fresh ATF again.
14-51
[1] CYLINDER COMP.
[3] DRIVE JOINT
[4] GEAR PUMP ASSEMBLY
[1]
GEAR PUMP CHAMBER
520
[2]
VISE
(ATF)
Publicidad
Capítulos
