Descargar Imprimir esta página

Honda BF40D Manual De Instrucciones página 438

Publicidad

9) Check that the piston rod is extended fully.
Warm up the upper joint metal/piston rod connecting area
with a dryer, and remove the upper joint metal while
1
holding the piston rod.
NOTICE
2
Do not warm up the upper joint metal/piston rod
connecting area excessively, as it can damage the oil tank
3
and/or the oil seal.
4
• Wear the gloves during this operation.
• After the piston rod cools down, remove the thread
5
locking agent from the threads and clean.
6
7
8
10) Remove the four 5 mm socket bolts, and remove the oil
9
tank and the motor wire bracket B.
• Remove the oil tank after the piston rod cools down.
10
11) Remove the O-ring from the cylinder comp.
11
Replace the O-ring with a new one on reassembly.
12
13
14
15
16
17
18
19
20
14-10
[1]
UPPER JOINT
METAL
[2] PISTON ROD
[1]
MOTOR WIRE
BRACKET B
[5] HARNESS BAND
CLIP (2)
438
[2] OIL TANK
[3]
5 mm SOCKET
BOLT (4)
[4] O-RING

Publicidad

loading

Este manual también es adecuado para:

Bf50d