Publicidad
d. INSTALLATION
1) Check that the "T " mark on the pulser rotor is in alignment
with the "T " mark on the cylinder head.
1
2
3
4
5
6
7
8
2) While aligning the "
9
" mark on the cylinder plate, set the guide plate on the
crankshaft with the "
10
3) Install the 25 x 14 mm woodruff key on the crankshaft.
11
4) Install the timing pulley with the projection toward down
while aligning the key groove in the timing pulley with the
12
25 x 14 mm woodruff key that is set on the crankshaft.
If there is clearance between the guide plate and the timing
13
pulley, remove the clearance by turning the guide plate.
Align the "
" mark on the guide plate with the "
on the timing pulley.
14
5) Install the timing belt guide plate on the crankshaft.
15
• Note the timing belt guide plate installation direction.
16
6) Apply engine oil to the threads and seat of the 48 mm lock
nut.
17
7) Loosely tighten the 48 mm lock nut.
18
19
20
7-13
" mark on the guide plate with the "
" mark toward up.
" mark
[1]
PULSER
ROTOR
[4]
CYLINDER
HEAD
[3]
"T " MARK
[1]
[2]
GUIDE PLATE
CRANKSHAFT
[5]
KEY GROOVE
[8]
[7]
TIMING BELT GUIDE PLATE
48 mm LOCK NUT
[6]
PROJECTION
42
[2]
"T " MARK
[3]
"
" MARK
[4]
" " MARK
[9]
TIMING PULLEY
[10]
25 x 14 mm
WOODRUFF
KEY
Publicidad
Capítulos
