Publicidad
35) Install the warning buzzer in the housing.
Route the warning buzzer wire between the projections in
1
the housing as shown.
2
• Operate the throttle arm and check it does not interfere
with the warning buzzer wire.
3
4
5
6
36) Install the emergency stop switch on the tiller handle
assembly aligning the cutout in the emergency stop switch
7
with the flat part in the switch installation part of the tiller
handle assembly as shown.
8
9
10
11
12
37) Install the nut on the combination switch and tighten the
13
nut to the specified torque.
14
TORQUE: 4.9 N . m (0.5 kgf . m, 3.6 lbf . ft)
15
38) Install the 16 mm hex nut on the emergency stop switch
and tighten the 16 mm hex nut to the specified torque.
16
TORQUE: 1.2 N . m (0.1 kgf . m, 0.9 lbf . ft)
17
18
19
20
16-30
[1]
WARNING
BUZZER
[4]
WARNING
BUZZER WIRE
[1] Align.
[2]
16 mm HEX NUT
[1]
COMBINATION
SWITCH
[4]
[5]
EMERGENCY
NUT
STOP SWITCH
618
[2] PROJECTIONS
[3] THROTTLE ARM
[2]
EMERGENCY
STOP SWITCH
[3]
TILLER HANDLE
ASSEMBLY
[3]
SWITCH
CLIP
Publicidad
Capítulos
