Publicidad
b. DISASSEMBLY/REASSEMBLY
1
• Never heat the gas assisted damper assembly, as it can
explode.
2
• Never disassemble the gas assisted damper assembly, as
it is filled with high pressured nitrogen gas.
3
• Be sure to release the gas from the gas assisted damper
assembly before disposing of it.
4
5
6
7
8
9
10
11
12
c. DISPOSAL
13
The gas assisted damper assembly is filled with the high
pressured gas. Observe the following instructions.
14
15
• Never heat the gas assisted damper assembly, as it can
explode.
16
• Never disassemble the gas assisted damper assembly, as
it is filled with high pressured nitrogen gas.
17
• Be sure to release the gas from the gas assisted damper
assembly before disposing of it.
18
1) Move the tilt lever to the "FREE" position with the piston
rod of the gas assisted damper assembly extended fully.
19
2) Wrap the gas assisted damper assembly in a vinyl bag, and
hold it upright in a vise as shown.
20
3) Inflate the vinyl bag with the cooling air from the drill
motor. While releasing air from the bag to prevent the bag
from bursting, release the gas from the gas assisted
damper assembly by drilling it at the plug bolt (specified
drill point). Wear the goggles during drilling and drill with
care not to let the vinyl bag get caught with the drill bit.
• Drill the gas assisted damper assembly at the specified
drill point.
• Be sure to wear the goggles during drilling. The gas and
drill chips will spurt out and scatter when drilling through
the gas assisted damper assembly.
14-57
WARNING
[1]
GAS ASSISTED
DAMPER ASSEMBLY
WARNING
[2]
TILT LEVER
[1]
PLUG BOLT
(DRILL POINT)
[2]
GAS ASSISTED
DAMPER
ASSEMBLY
532
[3]
6 mm SELF-LOCKING
NUT
12 N . m (1.2 kgf . m,
9 lbf . ft)
Publicidad
Capítulos
