Publicidad
4. PROPELLER SHAFT/PROPELLER
SHAFT HOLDER
1
a. DISASSEMBLY
2
Remove the following parts.
- Propeller (P. 11-2)
3
- Propeller shaft holder assembly (P. 11-7)
1) Remove the shift slider, #11 steel ball, propeller shaft
4
assembly, 22 mm washer and the 69 x 3.1 mm O-ring.
Replace the O-ring with a new one.
5
2) Before removing the 22 x 35 x 7 mm water seal, check the
water seal lip for cuts and damage and replace it with a
6
new one if necessary.
7
3) Remove the two 22 x 35 x 7 mm water seals from the
propeller shaft holder.
Replace the water seals with new ones.
8
9
10
11
12
4) Remove the cross pin ring and the 6.3 x 33 mm shifter pin,
13
then remove the clutch shifter.
14
15
16
17
18
19
5) Remove the shifter pin holder and the shift spring from the
propeller shaft.
20
11-9
[2]
PROPELLER SHAFT
ASSEMBLY
[1]
22 mm WASHER
[7]
22 x 35 x 7 mm
WATER SEAL (2)
[1]
[2]
6.3 x 33 mm
CLUTCH SHIFTER
SHIFTER PIN
[2]
SHIFTER PIN
[1]
HOLDER
PROPELLER
SHAFT
238
[4]
[3]
SHIFT
#11 STEEL
SLIDER
BALL
[5]
69 x 3.1 mm
O-RING
[6]
PROPELLER
SHAFT HOLDER
[3]
CROSS PIN
RING
[3]
SHIFT SPRING
Publicidad
Capítulos
