Publicidad
18) Loosen the throttle friction grip of the grip pipe assembly,
and turn the grip pipe assembly clockwise to remove it
from the tiller handle assembly.
1
2
3
4
5
6
19) Remove the throttle friction grip, throttle friction pad and
the throttle friction block from the grip pipe.
7
8
9
10
11
12
20) Open the two harness bands of the wire cover.
13
Replace the harness bands with new ones on reassembly.
Remove the two 5 x 10 mm screws, and remove the wire
14
cover.
15
• Power trim/tilt type only
16
21) Remove the 5 x 8 mm bolt and the 5 mm washer, and
remove the power tilt switch assembly.
Remove the switch grommet and the switch holder from
17
the power tilt switch.
Check the power tilt switch (P. 16-37) and replace it with a
18
new one if necessary.
19
• Power trim/tilt type only
Remove the 5 x 8 mm bolt and the 5 mm washer, and
20
remove the switch holder.
Remove the switch hole grommet.
• Gas assisted type only
16-14
[1]
GRIP PIPE
ASSEMBLY
[2]
THROTTLE
FRICTION
[1]
BLOCK
THROTTLE
FRICTION PAD
[1] *1: POWER TRIM/TILT TYPE ONLY
*2: GAS ASSISTED TYPE ONLY
[3]
*1 WIRE COVER
[2]
5 x 8 mm
BOLT
[10]
5 mm
WASHER
[9]
*1 POWER TILT
SWITCH
586
[2]
THROTTLE
FRICTION
GRIP
[3]
GRIP PIPE
[4]
THROTTLE
FRICTION GRIP
[4]
*1 5 x 10 mm
SCREW (2)
[5]
*1 HARNESS
BAND (2)
[6]
SWITCH
HOLDER
[7]
*2 SWITCH HOLE
GROMMET
[8]
*1 SWITCH GROMMET
Publicidad
Capítulos
