5) Install the cylinder head cover on the cylinder head.
6) After installation, move the cylinder head cover lightly from
1
side to side making sure that the gasket seats properly.
2
7) Loosely tighten the seven 6 x 35 mm flange bolts on the
cylinder head cover.
3
4
5
6
7
8
8) Tighten the seven 6 x 35 mm flange bolts in two or three
9
steps in the numbered sequence shown. Tighten to the
specified torque.
10
TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft)
11
12
13
14
15
16
17
9) Insert the oil tube up to the base into the cylinder head
cover.
18
Clamp the oil tube securely using the tube clamp D21.
19
20
9-32
[1]
CYLINDER HEAD
COVER
6 x 35 (7)
[1]
CYLINDER HEAD COVER
[2]
TUBE CLAMP
D21
[3]
OIL TUBE
150