Publicidad
c. REASSEMBLY
1) Tilt the outboard motor up and hold it in position by
hooking the chain on each of the three engine hangers.
1
2) Install the under cover rubber, extension case grommet,
2
drain plug rubber, and the two 6 x 10 mm dowel pins on the
extension case.
3
• Install the under cover rubber under the projection on the
extension case securely.
4
3) Apply marine grease to the inner wall of the extension case
5
grommet and drain plug rubber.
6
7
8
9
10
11
12
4) Pushing the 116 mm lead wire against the projection on the
13
lower mount center housing, install the 116 mm lead wire
by tightening the 6 x 8 mm screw securely.
14
15
16
17
18
19
20
11-52
[2]
(MARINE GREASE)
[1] EXTENSION
CASE GROMMET
[6]
6 x 10 mm
DOWEL PIN (2)
[5]
DRAIN PLUG
RUBBER
[4]
EXTENSION
CASE
[7]
PROJECTION
[3]
UNDER COVER
RUBBER
[4]
LOWER MOUNT
CENTER HOUSING
[1]
PROJECTION
324
[3]
UNDER COVER
RUBBER
[1]
PROJECTION
[2]
116 mm
LEAD WIRE
[3]
6 x 8 mm SCREW
[2]
116 mm
LEAD WIRE
Publicidad
Capítulos
