Publicidad
52) Tighten the outer tube guide to the specified torque.
NOTICE
1
To tighten the outer tube guide, use the special tool and
read the torque as follows.
2
TOOL:
Lock nut wrench
3
[3]
4
TORQUE WRENCH
5
6
7
[5] TORQUE WRENCH
8
• Formula:
9
[6] Torque wrench reading =
[7]
Torque wrench effective length [m (ft)] x Specified torque [N . m (kgf . m, lbf . ft)]
10
[7] Torque wrench effective length [m (ft)] + 0.05 [m (0.164 ft)]
11
TORQUE: 88 N . m (9.0 kgf . m, 65 lbf . ft)
12
• Example:
Torque wrench reading in case of using a torque wrench
which effective length is 0.4 m (1.31 ft)
13
0.4 [m (1.31 ft)] x 88 [N . m (9.0 kgf . m, 65 lbf . ft)]
14
0.4 [m (1.31 ft)] + 0.05 [m (0.164 ft)]
= 78 [N . m (8.0 kgf . m, 58 lbf . ft)]
15
Tighten the manual valve to the specified torque.
16
TORQUE: 1.7 N . m (0.2 kgf . m, 1.3 lbf . ft)
17
53) Apply ATF to a new oil seal and install it in the groove in
the oil tank.
18
Do not damage the oil seal during installation.
54) Apply ATF to a new O-ring and install it on the outer tube
19
guide.
20
55) Apply ATF to the piston rod, and install the oil tank while
turning it.
Do not damage the oil seal during installation.
56) Set the oil tank in the direction shown, and tighten the
5 mm socket bolts to the specified torque.
• Install and tighten the motor wire bracket B in the position
shown.
TORQUE: 4.7 N . m (0.5 kgf . m, 3.5 lbf . ft)
57) Remove the seal tape from the threads at the end of the
piston rod.
14-31
070PA-ZW40100
[4]
LOCK NUT WRENCH
[0.05 m
EFFECTIVE LENGTH
(0.164 ft)]
[m (ft)]
[8]
[2]
OUTER TUBE GUIDE
[1] Push the oil seal in
by lightly deforming
it.
[4] OIL SEAL
[5] 5 mm SOCKET
BOLT (4)
[10]
MOTOR WIRE
BRACKET B
[9] O-RING
480
[1]
LOCK NUT
WRENCH
070PA-ZW40100
[2]
Push in
aslant.
[3]
Hold the oil seal
in figure "U".
[6] OIL TANK
[7] SEAL TAPE
[8] OUTER TUBE
GUIDE
Publicidad
Capítulos
