Publicidad
[GAS ASSISTED TYPE]
Check that the piston rod of the gas assisted damper assembly
is extended fully.
1) Apply marine grease to the outer surface of the two swivel
case bushings, and install them on the swivel case
assembly.
2) Install a new 7/8-14 UNF self-locking nut on the R. stern
bracket side of the tilting shaft.
Tighten the 7/8-14 UNF self-locking nut fully to the end of
the threads of the tilting shaft.
3) Apply rust-preventive agent to the threads on the R. stern
bracket side of the tilting shaft, and install the tilting bolt
cap.
4) Install the R. stern bracket and the 22 mm wave washer on
the tilting shaft.
5) Install the swivel case assembly on the tilting shaft.
13-33
[1]
PISTON ROD
[2]
GAS ASSISTED
DAMPER ASSEMBLY
[1]
SWIVEL CASE BUSHING (2)
[9]
(MARINE
GREASE)
[8]
22 mm WAVE
WASHER
[7]
R. STERN
BRACKET
[6]
TILTING SHAFT
[5]
7/8-14 UNF SELF-
LOCKING NUT
412
[2]
SWIVEL CASE
ASSEMBLY
[3]
(Apply rust-
preventive
agent.)
[4]
TILTING BOLT CAP
Publicidad
Capítulos
