Honda BF40D Manual De Instrucciones página 684

6) Install the yoke on the front bracket aligning the marks
made on disassembly.
Before installation, check the magnetic part on the inner
side of the yoke for freedom from any foreign material.
7) Install the o-ring on the brush.
8) Set the brush on the brush holder, and install the four
brush springs.
9) Install the brush holder aligning the cutout in the brush
holder with the bolt hole in the yoke as shown.
10) Apply marine grease to the armature.
11) Install the rear washer on the armature.
18-13
[2]
FRONT
BRACKET
[1]
YOKE
[1]
BRUSH
SPRING (4)
[2]
REAR WASHER
[1]
(MARINE
GREASE)
[6]
YOKE
684
[3]
MARKS
[2]
O-RING
[3]
BRUSH
[4]
BRUSH
HOLDER
[3]
BRUSH HOLDER
[4]
CUTOUT
[5]
BOLT HOLE