Publicidad
9) Install the lower rubber mount on the extension case
aligning the cutout in the lower mount center housing with
the cutout in the lower rubber mount as shown.
1
10) Install the 12 mm washer [small] and the 12 x 162 mm hex
2
bolt. Holding the 12 x 162 mm hex bolt with a wrench,
tighten the 12 mm washer [large] and the 12 mm self-
locking nut to the specified torque.
3
TORQUE: 55 N . m (5.6 kgf . m, 41 lbf . ft)
4
5
6
7
8
9
10
11
12
11) Install the 116 mm lead wire on the extension case, and
13
tighten the 6 x 8 mm screw securely.
14
12) Install the lower mount housing on the extension case, and
tighten the two 8 x 25 mm flange bolts to the specified
15
torque.
TORQUE: 22 N . m (2.2 kgf . m, 16 lbf . ft)
16
13) Remove the engine hanger chain from the engine hangers,
17
and lower the outboard motor to the lowermost position.
18
19
20
11-54
[1]
12 x 162 mm
HEX BOLT
[2]
12 mm WASHER
[SMALL]
[3]
LOWER RUBBER
MOUNT
[4]
12 mm WASHER
[LARGE]
[5]
12 mm SELF-LOCKING NUT
[6]
LOWER MOUNT
CENTER HOUSING
[7]
CUTOUT
[2]
6 x 8 mm SCREW
[1]
LOWER MOUNT
HOUSING
[4]
8 x 25 (2)
8 mm WASHER (4)
328
[3]
LOWER RUBBER
MOUNT
[3]
116 mm
LEAD WIRE
Publicidad
Capítulos
