Publicidad
4) Using the special tool, compress the valve spring and set
the two valve keepers in the groove in the valve stem as
shown.
1
• To facilitate installation of the valve keepers, apply a
2
small amount of grease to the valve keepers and push
them in the groove in the valve stem.
3
TOOL:
Valve spring compressor
4
5
6
7
8
9
10
11
12
5) Tap the valve stem head lightly with a plastic hammer two
13
or three times, and set the valve stem and valve keepers in
the proper position securely.
14
• Tap each valve stem head straight down. Take care not to
15
bend the valve.
• Support the cylinder head with an engine table or
16
equivalent to prevent damage to the valve.
17
18
19
20
9-25
07757-0010000
[1]
VALVE SPRING
COMPRESSOR
07757-0010000
[3]
GROOVE
136
[2]
VALVE
KEEPER (2)
[1]
PLASTIC HAMMER
Publicidad
Capítulos
