Publicidad
5) Check the anode metal for corrosion. Replace the anode
metal with a new one if it is corroded excessively.
1
6) Set the 116 mm lead wire between the projections on the
anode metal as shown, and install the anode metal with the
2
two 6 x 23 mm flange bolts securely.
7) Tighten the 6 x 8 mm screw securely so that the 116 mm
3
lead wire on the power trim/tilt assembly side is installed at
the angle shown.
4
5
6
7
8
9
10
11
12
13
14
15
16
17
8) While holding the 7/8-14 UNF self-locking nut on the
R. stern bracket side, tighten the 7/8-14 UNF self-locking nut
18
on the L. stern bracket side to the specified torque.
19
TORQUE: 40 N . m (4.1 kgf . m, 30 lbf . ft)
20
9) After tightening to the specified torque, loosen the 7/8-14
UNF self-locking nut on the L. stern bracket side by
o
o
180
-210
.
After installing the 7/8-14 UNF self-locking nut, apply rust-
preventive agent to the threads of the tilting shaft.
Tighten the 10 mm self-locking nut of the 10 x 158 mm hex
bolt to the specified torque (P. 14-39).
TORQUE: 35 N . m (3.6 kgf . m, 26 lbf . ft)
Install the tilting bolt cap.
14-40
[1]
POWER TRIM/TILT
ASSEMBLY
[2]
116 mm LEAD
WIRE
6 x 23 (2)
[3]
ANODE METAL
[5] <Anode metal side>
[3]
ANODE
METAL
6 x 23
[6] PROJECTIONS
[7] <Power trim/tilt assembly side>
[2]
116 mm
LEAD
WIRE
[1]
L. STERN BRACKET
498
[4]
6 x 8 mm SCREW
[2]
116 mm
LEAD
WIRE
[4]
6 x 8 mm
SCREW
[2]
TILTING
BOLT CAP
[3]
7/8-14 UNF SELF-
LOCKING NUT
Publicidad
Capítulos
