Publicidad
4) Apply engine oil to the outer surface of a new 13.8 x 2.5
mm O-ring and install it on the oil strainer.
1
5) Set the oil case gasket on the primary gear case.
Install the oil strainer on the primary gear case and tighten
2
the two 6 x 16 mm flange bolts to the specified torque.
TORQUE: 13 N . m (1.3 kgf . m, 10 lbf . ft)
3
4
5
6
7
8
9
10
11
12
6) Install the oil case on the primary gear case and tighten the
13
eleven 6 x 25 mm flange bolts to the specified torque.
14
TORQUE: 10 N . m (1.0 kgf . m, 7 lbf . ft)
15
7) Tighten a new 12 mm drain plug washer and oil drain plug
bolt to the specified torque.
16
TORQUE: 23 N . m (2.3 kgf . m, 17 lbf . ft)
17
8) Install the oil level gauge.
18
19
20
11-58
[3] 13.8 x 2.5 mm
O-RING
[4]
OIL STRAINER
[3]
OIL CASE
[4]
OIL DRAIN
PLUG BOLT
6 x 25 (11)
336
[1]
PRIMARY
GEAR CASE
[2]
OIL CASE
GASKET
6 x 16 (2)
[1]
OIL LEVEL
GAUGE
[2]
12 mm DRAIN
PLUG WASHER
Publicidad
Capítulos
